Ändra sökning
RefereraExporteraLänk till posten
Permanent länk

Direktlänk
Referera
Referensformat
  • apa
  • harvard1
  • ieee
  • modern-language-association-8th-edition
  • vancouver
  • Annat format
Fler format
Språk
  • de-DE
  • en-GB
  • en-US
  • fi-FI
  • nn-NO
  • nn-NB
  • sv-SE
  • Annat språk
Fler språk
Utmatningsformat
  • html
  • text
  • asciidoc
  • rtf
A model for vehicle-induced non-tailpipe emissions of particles along Swedish roads
SMHI, Forskningsavdelningen, Luftmiljö.ORCID-id: 0000-0001-6713-5741
2005 (Engelska)Ingår i: Atmospheric Environment, ISSN 1352-2310, E-ISSN 1873-2844, Vol. 39, nr 33, s. 6088-6097Artikel i tidskrift (Refereegranskat) Published
Abstract [en]

One of the most important parameters that controls the suspension of road dust particles in the air is road surface moisture. This is calculated every hour from a budget equation that takes into account precipitation, evaporation and runoff. During wet conditions a road dust layer is built up from road wear which strongly depends on the use of studded tyres and road sanding. The dust layer is reduced during dry road conditions by suspension of particles due to vehicle-induced turbulence. The dust layer is also reduced by wash-off due to precipitation. Direct non-tailpipe vehicle emissions due to the wear and tear of the road surface, brakes and tyres are accounted for in the traditional way as constant emission factors expressed as mass emitted per vehicle kilometre. The model results are compared with measurements from both a narrow street canyon in the city centre of Stockholm and from an open highway outside the city. The model is able to account for the main features in the day-to-day mean PM10 variability for the street canyon and for the highway. A peak in the PM10 concentration is typically observed in late winter and early spring in the Nordic countries where studded tyres are used. This behaviour is due to a combination of factors: frequent conditions with dry roads, high number of cars with studded tyres and an accumulated road dust layer that increases suspension of particles. The study shows that using a constant emission factor for PM10 or relating PM10 emissions to NOx cannot be used for prediction of day-to-day variations in PM10 concentrations in the traffic environments studied here. The model needs to describe variations in dust load, wetness of the road and how dust suspension interacts with these processes. (c) 2005 Elsevier Ltd. All rights reserved.

Ort, förlag, år, upplaga, sidor
2005. Vol. 39, nr 33, s. 6088-6097
Nyckelord [en]
road dust, road wear, suspension, coarse particles, PM10, PM2.5
Nationell ämneskategori
Miljövetenskap
Forskningsämne
Miljö
Identifikatorer
URN: urn:nbn:se:smhi:diva-1263DOI: 10.1016/j.atmosenv.2005.06.037ISI: 000232762600007OAI: oai:DiVA.org:smhi-1263DiVA, id: diva2:843238
Tillgänglig från: 2015-07-28 Skapad: 2015-05-26 Senast uppdaterad: 2017-12-04Bibliografiskt granskad

Open Access i DiVA

Fulltext saknas i DiVA

Övriga länkar

Förlagets fulltext

Personposter BETA

Omstedt, Gunnar

Sök vidare i DiVA

Av författaren/redaktören
Omstedt, Gunnar
Av organisationen
Luftmiljö
I samma tidskrift
Atmospheric Environment
Miljövetenskap

Sök vidare utanför DiVA

GoogleGoogle Scholar

doi
urn-nbn

Altmetricpoäng

doi
urn-nbn
Totalt: 52 träffar
RefereraExporteraLänk till posten
Permanent länk

Direktlänk
Referera
Referensformat
  • apa
  • harvard1
  • ieee
  • modern-language-association-8th-edition
  • vancouver
  • Annat format
Fler format
Språk
  • de-DE
  • en-GB
  • en-US
  • fi-FI
  • nn-NO
  • nn-NB
  • sv-SE
  • Annat språk
Fler språk
Utmatningsformat
  • html
  • text
  • asciidoc
  • rtf
v. 2.35.8
|